Member
Joined
Nov 18, 2019
Messages
8
Reaction score
1
Points
3
Hi, guys!
I friend of mine just gave me a mint looking PC Engine Duo RX that doesnt wanna turn on..
It has been RGB modded around 15 years ago and he said me it was working fine until a few years ago..
The PCB is like new, but the console is completely dead when I try to turn it on. Even the led stays off.
I just can just hear some slight "noise" if I get my ear close to the mainboard. Caps seem ok, no leaks.
I checked the Voltage regulators with a multimeter, but boths work fine.
Do you have any idea? do you recommend me to replace all the caps anyway?
Here is a picture

Thank you all!
 

Attachments

  • 2019-11-16 11.04.04.jpg
    2019-11-16 11.04.04.jpg
    1.4 MB · Views: 0
New member
Joined
May 31, 2019
Messages
3
Reaction score
0
Points
1
Hi. Not sure if this helps but is worth to mention that the led only signals CD access, not power on/off. Press the run button after turning it on.
 
Well-known member
Registered
Joined
Jun 1, 2019
Messages
65
Reaction score
3
Points
8
Could be the RGB mod. Maybe a wire has become disconnected? Also the RGBS signals should be amplified.
 
Donator
Donator
Registered
Joined
Nov 25, 2019
Messages
54
Reaction score
18
Points
8
I would try removing the RGB mod and seeing if it powers on, or checking continuity between all of the wires to make sure nothing's shorted. Also make sure all the crystals are okay, weird clock cycles could cause it to fail powering on.
 
Well-known member
Registered
Joined
Jun 1, 2019
Messages
65
Reaction score
3
Points
8
Yess. Remove the RGBS mod and reconnect the composite video signal to see if it works that way.
 
New member
Joined
Jun 4, 2019
Messages
2
Reaction score
0
Points
1
The board looks mint, no visual signs of leaky/faulty caps apart from the one next to the switch that looks slightly back on top but it could be a shadow. That RGB mod worries me though, I don't see any insulation on the cables soldered to the RGB connector. I blew a fuse recently on a Coregrafx doing an RGB mod learned my lesson and added insulation on each cable. Apparently there is no fuse on the RX, I'd also suggest removing the RGB mod and re-instate composite. Without an RGB amp, the picture won't look great anyway.
 
Member
Joined
Nov 18, 2019
Messages
8
Reaction score
1
Points
3
Thanks guys for your help! I will follow your advices. Sorry for the late reply >.<
However even if the mod is faulty, shouldn't the cd spin? When I connect to my tv I can just se a white flash image and then black..
 
Top