• Welcome Back Guest,
    There's currently a few rebranding bugs, one being emails aren't working, we're aware of this and will work on this as we have time. If you need a password reset, please contact us on Discord links in the navbar.

GC Controller 1 won't vibrate

C

clueless

Active member
Registered
Joined
Sep 5, 2019
Messages
33
I just discovered that my controller won't vibrate on the first port. The other ports though work normally.

I tried to reflow the solder points both on the port and the ribbon cable, but nothing changed. Is there anything else I can try to fix this issue?
That specific board, had also a dead clock battery that I replaced
 
Have you tried to check if there is any oxidation in the port (connector) itself? Because if your controller vibrates in any other port, the problem is probably port related then.
 
First thing I did, was clean the connector for any possible oxidation/dirt/grime . I also inspected it visually if there are any visible signs of oxidation.
Nothing seems to be wrong.

What I noticed though, is that it feels kinda loose when I plug-unplug a controller. All the other ports have a firmer grip.
If I had a desoldering gun I would try to swap the connectors from port 3 and 4 to the port 1 and 2
 
Do you have a multimeter? There should be 5V present on the top left pin on the controller port. Ground is top right. 5V is only used for Rumble. If there is no 5V it might be easier to just jump the 5V from another port with a wire.
 
Shizzy said:
Do you have a multimeter? There should be 5V present on the top left pin on the controller port. Ground is top right. 5V is only used for Rumble. If there is no 5V it might be easier to just jump the 5V from another port with a wire.
Click to expand...
I haven't even thought of that! I feel so naive for not thinking something simple like that :)
 
You must log in or register to reply here.
Back
Top Bottom